The study of burning behaviors and quantitative risk assessment for 0# diesel oil pool fires

The liquid fuel safety issues on fuel storage, transportation and processing have gained most attention because of the high fire risk. In this paper, some 0# diesel pool fire experiments with different diameters (0.2–1 m) were conducted with initial fuel thicknesses of 2 cm and 4 cm, respectively, to obtain liquid fuel combustion characteristics. Some key parameters including mass burning rate, flame height and the flame radiative heat flux, associated with fire risk, were investigated and determined. Subsequently, a detail quantitative risk assessment framework for 0# diesel pool fire is proposed based on the 0# diesel burning characteristics. In the framework, the probability of personal dead and the facility failure are calculated by the vulnerability models, respectively. In the end, 10 special tank fire scenarios were selected to show the whole risk calculation process. The tank diameter and the distance to pool fires were paid more attention in the cases. The safety distances in the cases are provided for the persons and nearby facilities, respectively. The paper enriches the basic experimental data and the provided framework is useful to the management of 0# diesel tank areas.     

温拌阻燃沥青混合料阻燃效果评价

通过氧指数、质量损失率及路用性能试验,研究EC130温拌剂、FRMAX型阻燃剂对沥青混合料阻燃效果的影响。试验结果显示,相比普通沥青混合料,阻燃沥青混合料、温拌阻燃沥青混合料氧指数分别增加23.3%、25.6%,质量损失率减小28.0%、32.0%,残留动稳定度增加14.0%、16.1%,残留最大弯拉应变增加14.1%、17.1%,冻融劈裂强度比增加5.3%、9.0%。相比普通沥青路面,阻燃沥青路面、温拌阻燃沥青路面发生火灾时能够减少34.0%、41.1%的毒害气体生成,并减少路面修补所需的混合料质量。其次得出普通沥青路面、阻燃沥青路面及温拌阻燃沥青路面的质量损失率、残留动稳定度、残留最大弯拉应变、残留冻融劈裂强度比与燃烧时间的关系模型。结果表明:阻燃剂对沥青混合料的阻燃效果显著;温拌剂有助于阻燃剂更好地发挥阻燃作用,降低火灾对道路的破坏,降低隧道火灾发生时有害气体的生成,提升隧道安全性。     

动态水流条件下河流底泥污染物(COD_(Cr))释放研究

为了研究不同水深、流速等水动力条件对底泥中污染物释放强度的影响,以苏州河底泥为例,通过水槽试验,分析了动态水流条件下河流底泥中污染物释放及其对上覆水体水质的影响.结果表明,CODCr释放率随时间的增大而增大,但CODCr释放强度随时间的增大而减小.底泥中污染物释放率与水深和流速有关,在相同水深的条件下,底泥的释放率随着流速的增加而增大;在相同流速的条件下,底泥的释放率随着水深的增大而减小.在水深10cm、流速0.10m.s-1的动态水流条件下,底泥向上覆水体释放CODCr的释放强度与时间的关系为:C=1.06C0e-0.06t.     

尿素对中国近海3种典型赤潮藻生长的影响

采用实验室一次性培养的方法,研究了尿素对中国近海3种赤潮藻---球形棕囊藻(Phaeocystis globosa)、锥状斯氏藻(Scrippsiellatrochoidea)和中肋骨条藻(Skeletonema costatum)生长的影响.结果表明,这3种赤潮藻均能利用有机氮源尿素生长,且表现出明显的浓度效应:当尿素浓度介于0~8.82μmol.L-1(以N计,下同)时,3种赤潮藻的比生长速率均较低,细胞密度也较低,与对照组相比无显著差异;当尿素浓度大于8.82μmol.L-1时,这3种赤潮藻表现出明显的生长效应.然而,3种赤潮藻适宜生长的尿素浓度并不一致,当尿素浓度分别为882、8820和8820μmol.L-1时,球形棕囊藻、锥状斯氏藻和中肋骨条藻分别达到最大比生长率0.76、0.54和0.66d-1.将3种赤潮藻在不同尿素浓度下的最大比生长速率用Monod方程拟合,得出球形棕囊藻、锥状斯氏藻和中肋骨条藻在以尿素为唯一氮源条件下的最大比生长速率和半饱和常数分别为0.73、0.47、0.63d-1和12.36、21.83和20.34μmo.lL-1.由此可见,这3种藻能够利用有机氮源尿素,无疑扩展了其氮营养来源,在无机氮源缺乏时,具有竞争优势.相比较而言,球形棕囊藻对尿素的亲和力最高,在低浓度尿素条件下,球形棕囊藻具有较高的竞争力.     

上海市城区春节和“五一”节期间大气挥发性有机物的组成特征

挥发性有机物(VOCs)是对流层臭氧和二次有机气溶胶等二次污染生成过程的关键前体物.研究VOCs的浓度水平、组成特征和反应活性对揭示复合型大气污染的形成机制具有重要意义.本研究利用在线气相-氢离子火焰法测量了2009年春节和"五一"节期间上海市城区大气中56种VOCs.结果表明,上海市城区大气受机动车尾气排放源影响明显,VOCs浓度日变化特征呈双峰状,与上下班交通高峰基本吻合.大气中VOCs平均体积分数为(28.39±18.35)×10-9;各组分百分含量依次为:烷烃46.6%,芳香烃27.0%,烯烃15.1%,乙炔11.2%.用OH消耗速率和臭氧生成潜势(OFP)评估了VOCs大气化学反应活性,结果表明,上海市城区大气VOCs化学反应活性与VOCs体积浓度相关性良好;VOCs活性与乙烯相当,平均化学反应活性较强;OH消耗速率贡献最大的物种是烯烃51.2%和芳香烃31.8%;OFP贡献最大的物种是芳香烃53.4%和烯烃30.2%;对臭氧生成贡献最大的关键活性物种为丙烯、乙烯、甲苯、二甲苯以及丁烯类物质.     

Multiple linear regression models of urban runoff pollutant load and event mean concentration considering rainfall variables

Rainfall is an important factor in estimating the event mean concentration (EMC) which is used to quantify the washed-off pollutant concentrations from non-point sources (NPSs). Pollutant loads could also be calculated using rainfall, catchment area and runoff coefficient. In this study, runoff quantity and quality data gathered from a 28-month monitoring conducted on the road and parking lot sites in Korea were evaluated using multiple linear regression (MLR) to develop equations for estimating pollutant loads and EMCs as a function of rainfall variables. The results revealed that total event rainfall and average rainfall intensity are possible predictors of pollutant loads. Overall, the models are indicators of the high uncertainties of NPSs; perhaps estimation of EMCs and loads could be accurately obtained by means of water quality sampling or a long term monitoring is needed to gather more data that can be used for the development of estimation models.     

高浓度服装水洗废水的混凝处理研究

采用化学混凝法,以PAC为混凝剂,PAM为助凝剂,对高浓度服装水洗废水进行处理研究。考察了溶液的pH值、PAC的投加量、PAM的用量等因素对脱色率及COD去除率的影响,得到最佳工艺条件为:pH为8.0左右,PAC投加量为25mL/L(废水),PAM的投加量为1.0mL/L(废水)。在此条件下,服装水洗废水的脱色率为73.1%,COD的去除率为72.1%。     

含钛高炉渣制光催化剂降解水中2,4-二氯酚的研究

以攀钢含钛高炉渣为原料制备了光催化剂,并将其用于降解水中2,4-二氯酚,研究了光催化剂投加量、光照强度、反应物浓度、反应时间对2,4-二氯酚降解率的影响。结果表明:高炉渣制光催化剂对2,4-二氯酚具有良好的光催化效果,在催化剂投加量为0.3g/L,光照时间为2h的条件下,浓度为50mg/L的2,4-二氯酚的降解率达到了77.1%。通过反应的动力学分析,确立出高炉渣制光催化剂对水中2,4-二氯酚的降解反应为一级反应。对2,4-二氯酚的光催化降解产物进行分析发现,苯环上的C—Cl键被光催化剂产生的羟自由基·OH氧化断裂,氯取代基成为游离Cl-存在于溶液中,2,4-二氯酚被·OH降解生成中间小分子有机产物,这些小分子有机物再进一步被光催化降解。     

含氚硅胶密封包装实验研究

文章针对含氚硅胶,设计了双层桶密封包装容器,即以镀膜铝桶为初始包装,内衬高密度聚乙烯(HDPE)不锈钢桶为外包装容器。含氚硅胶在镀膜铝桶内用环氧树脂浇注固定,密封;铝桶放入衬HDPE不锈钢外桶,间隙蛭石填充,垫圈密封。含氚硅胶包装桶氚释气率测量结果表明,20天内日均释氚率为4.62×10-5%;浸出实验结果表明,108天内氚日均浸出率远小于10-3%,满足氚废物包装的相关要求。     

不锈钢-铝电极电絮凝处理含铜废水的试验研究

采用不锈钢-铝为电极的电絮凝法对含铜废水进行了处理试验研究,模拟废水铜离子浓度为150 mg/L,以废水中的铜离子浓度和COD去除率为考察指标,在电流密度为15 mA/cm2、极板间距为3 cm、pH值为7、电解时间为120 min的条件下,Cu2+的去除率平均能达到99%以上,COD的去除率亦能达到97%;在此基础上,应用于实际的电路板腐蚀液废水的处理试验,发现Cl-浓度在200 mg/L以上时,对废水先进行相关预处理也能达到较好的处理效果,该研究对进一步探讨Cl-对电絮凝的影响机理有一定的借鉴意义。